Although possible it is very difficult and not recommended.
Cutting aluminum sheet with scroll saw.
Harder metals should not be cut using a scroll saw.
You can get metal cutting blades for both.
You can use a scroll saw to cut through just about any type of metal including aluminum copper brass bronze and cold rolled steel.
Cutting 1 4 inch aluminum on a scroll saw would be pushing it but if you cut very slowly you should be able to do it.
Equipped with a metal cutting blade the scroll saw can cut soft metal such as copper silver brass and aluminum up to 1 8 thick as well as 1 8 brass rod.
I would not cut 1 8 thick aluminum on a scroll saw unless it was a last ditch effort.
The action of a scroll saw blade makes cutting metal kind of dangerous.
There s snapping blades metal chips flying and potential for the workpiece to catch the blade wrong and send it flying or at least vibrate violently.
If you have a thicker metal you ll probably want to use a circular saw or bandsaw to make your cuts.
I have cut some brass on the saw in a pinch but swore that i would never do it again.
If the hard metal is thicker than a quarter inch find another saw.
If it s straight then use a compound mitre saw with a carbide blade goes though it like butter.
Therefore it is advised that harder metals should not be cut using a scroll saw.
Work slowly as you feed the metal through the blade.
It is possible to cut harder metals with a scroll saw.
If you are absolutely dedicated to doing so use a slow speed setting make sure the blade is properly lubricated and feed the metal through the blade slowly.
Sheets can be taped between pieces of 1 8 plywood to prevent burrs on the underside keep shavings under control and protect the saw table.
Cutting metal on a scroll saw is definitely not as safe as cutting wood.
A scroll saw can be used to cut soft metal up to inches thick.
